Overview
EN ISO 16032:2024 - "Acoustics - Measurement of sound pressure level from service equipment or activities in buildings - Engineering method" - specifies an engineering method for measuring sound pressure levels produced inside rooms by building service equipment and by activities (for example, kitchen or sports/music noise). It replaces the 2004 edition and is intended for typical room volumes of approximately 300 m³ or less (dwellings, hotels, schools, offices, hospitals). The standard explicitly excludes measurements of noise from external sound sources that generate airborne or ground‑borne noise in the building, and it is not intended for large auditoria or concert halls.
Key topics and technical requirements
- Scope of sources: sanitary installations, mechanical ventilation, heating/cooling equipment, lifts, rubbish chutes, pumps, blowers, motor‑driven car park doors, and similarly placed activities (e.g., restaurant or sports facility noise).
- Measurement basis: one‑third‑octave‑band measurements are required; octave‑band results may be reported optionally but are not used for A‑ or C‑weighted calculations.
- Frequency range: A‑ and C‑weighted levels can include one‑third‑octave bands from 25 Hz to 10 000 Hz, but must always include 50 Hz to 5 000 Hz; reverberation‑time standardization applies to 50 Hz–5 000 Hz.
- Measured quantities: equivalent continuous sound pressure level (Leq) and maximum sound pressure level (L_Smax) with specified time weighting; procedures for averaging spatial/temporal variations are revised versus the previous edition.
- Measurement procedure elements: microphone corner selection, reverberant‑field microphone positions, background noise determination, averaging methods, correction for background noise, and reporting requirements.
- Reverberation time: measurement and normalization procedures (references ISO 3382‑2).
- Documentation: annexes include operating conditions/operating cycles (Annex B) and an example results form (Annex C); Annex A provides A‑ and C‑weighting correction values.
- Equipment & calibration: conformity to relevant IEC/ISO electroacoustic standards (e.g., IEC 61672‑1, IEC 61260‑1, IEC 60942).
Practical applications
- Verifying compliance with building regulations and acoustic criteria for residential and commercial buildings.
- Assessing noise from HVAC systems, lifts, pumps, and other building services during design, commissioning, or troubleshooting.
- Producing test reports for building acoustics consultants, facilities managers, architects, and contractors.
- Measuring activity noise inside mixed‑use buildings (restaurants, sports rooms) to evaluate disturbance and mitigation needs.
Who uses this standard
- Acoustic consultants and engineers
- Building services and mechanical engineers
- Commissioning teams and facility managers
- Regulatory authorities and building control bodies
- Architects and planners assessing occupant noise exposure
Related standards (normative references)
Keywords: EN ISO 16032:2024, acoustics, sound pressure level, one‑third‑octave bands, building services noise, reverberation time, A‑weighted, C‑weighted, background noise correction.