SIST ISO 7801:1996 PDF

Overview

SIST ISO 7801:1996 is an international standard published by the International Organization for Standardization (ISO) that specifies a method for testing the plastic deformation ability of metallic wire through a reverse bend test. Applicable to wires with diameters or thicknesses ranging from 0.3 mm to 10 mm inclusive, this standard measures the wire's durability and resistance to cracking or fracture when subjected to repetitive bending in opposite directions.

The reverse bend test assesses wire quality by simulating mechanical stresses it might undergo during bending applications. The test involves bending the wire repeatedly at a 90° angle over cylindrical supports with a defined radius, ensuring consistent and reproducible test conditions.

Key Topics

• Scope and Application: Suitable for metallic wires with diameters between 0.3 mm and 10 mm, with exact applicability potentially defined in specific product standards.
• Test Principle: The wire test piece is repeatedly bent 90° in one direction and then reversed over a cylindrical support, testing its plastic deformation capacity.
• Test Setup:
  • Use of cylindrical supports with specified radius and hardness.
  • Bending arm and guide system ensuring the wire bends precisely.
  • Test carried out at ambient temperature between 10 °C and 35 °C, with 23 ± 5 °C as a controlled condition.
• Test Procedure:
  • Wire is inserted vertically and bent through 90° alternate bends without shock.
  • A bending rate not exceeding one bend per second prevents heat effects.
  • Tensile stress may be applied up to 2% of nominal tensile strength to maintain contact.
  • Test continues until visible cracking or complete fracture occurs.
• Test Piece Preparation:
  • Wire should be as straight as possible, with slight curvature allowed.
  • Straightening by hand or gentle hammering on soft surfaces without damaging wire surface.
  • Sharp local curvatures are grounds to reject the test piece.
• Reporting: The test report includes the standard reference, wire identification, dimensions, test conditions, and results regarding the number of reverse bends endured before failure.

Applications

• Quality Control in Wire Manufacturing: Ensures that wire products meet minimum ductility and mechanical integrity standards before being released to market.
• Material Research and Development: Helps in evaluating new alloys or wire treatments by benchmarking their resistance to plastic deformation.
• Industrial Component Design: Applicable in industries where wires undergo frequent bending, such as automotive cables, springs, electrical wiring, and animal husbandry wire products.
• Failure Analysis: Identifies limitations of wire materials under repeated flexing conditions, guiding improvements in manufacturing processes.
• Regulatory Compliance: Assists manufacturers to comply with international standards related to wire mechanical testing, enhancing product consistency and safety.

Related Standards

• ISO 1441:1973 (Replaced by ISO 7801) - Former standard for bend tests on metallic wires.
• ISO 2625:1973 (Replaced by ISO 7801) - Early method for wire bend testing.
• ISO 6892 - Metallic materials - Tensile testing (complements bend testing by providing tensile strength data).
• ISO 4540 - Metallic materials - Wire - Determination of coating mass (may be relevant when coated wires are subjected to bend tests).
• ISO 12310 - General metallic materials testing standards that may cover other deformation tests.

Keywords: ISO 7801, reverse bend test, wire testing, metallic wire, plastic deformation, wire diameter, wire bend test, mechanical testing of metals, wire quality control, international standards for wire bending