BS EN IEC 61788-25:2018
Superconductivity - Mechanical properties measurement. Room temperature tensile test on REBCO wires
Superconductivity - Mechanical properties measurement. Room temperature tensile test on REBCO wires
- Статус документа:
- Действующий
- Формат:
- Электронный (PDF)
- Дата публикации:
- 30 ноября 2018 г.
- ICS:
- 29.050
- Технический комитет:
- CENELEC
- SKU:
- BS EN IEC 61788-25:2018
Abstract
What is BS EN IEC 61788-25- Superconductivity about?
BS EN IEC 61788-25 is the 25 th part of the IEC 61788 series that discusses superconductivity. This European standard helps its users to measure the superconductivity of REBCO wires. BS EN IEC 61788-25 applies to samples having a rectangular cross-section with an area of 0,12 mm2 to 6,0 mm2 (corresponding to the tapes with width of 2,0 mm to 12,0 mm and thickness of 0,06 mm to 0,5 mm).
Who is BS EN IEC 61788-25- Superconductivity for?
BS EN IEC 61788-25 on r oom temperature tensile test on REBCO wires is beneficial for:
Electrical and Mechanical engineers
<li data-leveltext="" data-font="Symbol" data-listid="...Похожие стандарты
Упомянутые в описании и другие стандарты BS
IEC 61788-25:2018
ДействующийSuperconductivity - Part 25: Mechanical properties measurement - Room temperature tensile test on REBCO wires
Overview IEC 61788-25:2018 is an international standard developed by the International Electrotechnical Commission (IEC) that specifies the test methods and procedures for measuring the tensile mecha…
IEC 61788-23:2024
ДействующийSuperconductivity - Part 23: Residual resistance ratio measurement - Residual resistance ratio of cavity-grad…
Overview IEC 61788-23:2024 - Superconductivity: Residual resistance ratio measurement defines a standardized test method to determine the residual resistance ratio (RRR, rRRR) of cavity-grade niobium…
BS ISO 10835:2007
ДействующийDirect reduced iron and hot briquetted iron. Sampling and sample preparation.
1 Scope This International Standard gives a) the underlying theory, b) the basic principles for sampling and preparation of samples , and c) the basic requirements for the design, installation and op…