BS ISO 12151-2:2003
Connections for hydraulic fluid power and general use. Hose fittings - Part 2: Hose fittings with ISO 8434-1 and ISO 8434-4 24° cone connector ends with O-rings
Connections for hydraulic fluid power and general use. Hose fittings - Part 2: Hose fittings with ISO 8434-1 and ISO 8434-4 24° cone connector ends with O-rings
- Статус документа:
- Отменён
- Формат:
- Электронный (PDF)
- Дата публикации:
- 16 июля 2003 г.
- ICS:
- 23.040.70
- SKU:
- BS ISO 12151-2:2003
Abstract
1 Scope This part of ISO 12151 specifies the general and dimensional requirements for the design and performance of hose fittings with 24° cone connector ends with O-rings, in accordance with ISO 8434-1 and ISO 8434-4. These hose fittings are made of carbon steel and are intended for use with hoses with nominal inside diameters from 5 mm through 38 mm (inclusive).
NOTE 1 Materials other than carbon steel may be supplied as agreed between the manufacturer and user.
NOTE 2 For hose fittings used in hydraulic and pneumatic braking systems on road vehicles (as defined in the scope of ISO/TC 22), see [ISO 4038](/search?q=ISO%C2%A04038), [ISO 4039-1](/search?q=ISO%C2%A04039-1) and [ISO 4039-2](/search?q=ISO%C2%A04039-2).
These hose fittings (see Figure 1 for a typical example) are for use in fluid power systems with hoses that meet the requirements of respective standards and in general applications with suitable hoses.
Похожие стандарты
Стандарты, упомянутые в описании
BS ISO 12151-6:2009
ДействующийConnections for hydraulic fluid power and general use. Hose fittings. Hose fittings with ISO 8434-6 60° cone…
ISO 8434-1:2018
ДействующийMetallic tube connections for fluid power and general use — Part 1: 24° cone connectors
Overview ISO 8434-1:2018 - Metallic tube connections for fluid power and general use - Part 1: 24° cone connectors specifies general and dimensional requirements for 24° cone tube connectors using cu…
ISO 8434-4:1995
ОтменёнMetallic tube connections for fluid power and general use — Part 4: 24 degree cone connectors with O-ring wel…
ISO 4038:1996
ДействующийRoad vehicles — Hydraulic braking systems — Simple flare pipes, tapped holes, male fittings and hose end fitt…
Overview ISO 4038:1996 specifies essential dimensions and physical characteristics for metallic pipes and fittings used in hydraulic braking systems for road vehicles. The third edition (1996) update…
ISO 4039-1:1998
ДействующийRoad vehicles — Pneumatic braking systems — Part 1: Pipes, male fittings and tapped holes with facial sealing…
Overview ISO 4039-1:1998 is an international standard for pneumatic braking systems on road vehicles. It specifies the essential dimensions, material and surface requirements for metallic and thermop…
ISO 4039-2:1998
ДействующийRoad vehicles — Pneumatic braking systems — Part 2: Pipes, male fittings and holes with conical sealing surfa…
Overview ISO 4039-2:1998 specifies essential dimensions and material/surface requirements for pipes, male fittings and tapped holes with conical sealing surfaces used in road-vehicle pneumatic brakin…