BS ISO 21501-3:2007
Determination of particle size distribution. Single particle light interaction methods - Light extinction liquid-borne particle counter
Determination of particle size distribution. Single particle light interaction methods - Light extinction liquid-borne particle counter
- Статус документа:
- Отменён
- Формат:
- Электронный (PDF)
- Дата публикации:
- 31 августа 2007 г.
- ICS:
- 19.120
- SKU:
- BS ISO 21501-3:2007
Abstract
1 Scope This part of ISO 21501 describes a calibration and verification method for a light extinction liquid-borne particle counter (LELPC), which is used to measure the size and particle number concentration of particles suspended in liquid. The light extinction method described in this part of ISO 21501 is based on single particle measurements. The typical size range of particles measured by this method is between 1 µm and 100 µm in particle size. Instruments that conform to this part of ISO 21501 are used for the evaluation of the cleanliness of pharmaceutical products (e.g. injections, water for injections, infusions), as well as the measurement of number and size distribution of particles in various liquids. The following are within the scope of this part of ISO 21501:
— size calibration;
— verification of size setting;
— counting efficiency ;
— size resolution ;
— maximum particle number concentration;
— sampling flow rate;
— sampling time;
<div cla...
Похожие стандарты
Упомянутые в описании и другие стандарты BS
ISO 21501-4:2018
ДействующийDetermination of particle size distribution — Single particle light interaction methods — Part 4: Light scatt…
Overview ISO 21501-4:2018 specifies calibration and verification methods for light scattering airborne particle counters (LSAPC) used in clean spaces. The standard covers single-particle light intera…
BS ISO 10835:2007
ДействующийDirect reduced iron and hot briquetted iron. Sampling and sample preparation.
1 Scope This International Standard gives a) the underlying theory, b) the basic principles for sampling and preparation of samples , and c) the basic requirements for the design, installation and op…