ISO 13887:2017

Overview

ISO 13887:2017 specifies requirements for cold‑reduced steel sheet of higher yield strength with improved formability. It covers production, chemical composition, mechanical properties, surface condition, dimensional tolerances and testing for steel sheet intended for fabrication of parts requiring enhanced formability. Typical product forms are coils and cut lengths (thicknesses from 0.25 mm to 3.2 mm, widths 600 mm and over). The standard is normally used for material in the delivered condition and excludes commercial/drawing quality, structural quality and certain high‑tensile/low‑yield steels.

Key topics and technical requirements

• Grades and chemistry: Defined grades (e.g., 260Y, 300Y, 340Y, 380Y, 420Y, 490Y, 550Y) with maximum limits for C, Mn, S and Si. Additional alloying elements (Cu, Ni, Cr, Mo, Nb, V, Ti) have specified limits and sum constraints for heat and product analyses.
• Mechanical properties: Minimum lower yield strength, tensile strength and elongation requirements are specified per grade (values given for representative gage lengths). Users can request mechanical property reports at shipment.
• Manufacturing practice: Steelmaking and fine‑grain practice are left to the manufacturer unless otherwise agreed; heat analysis and product analysis requirements are defined.
• Testing and sampling: Tensile testing is performed per ISO 6892‑1. One representative transverse sample per lot (≤50 t) is taken; transverse specimens are taken midway between centre and edge of the sheet as rolled.
• Surface and finish: Matte (dull) finish typical; surface condition requirements differ for exposed vs unexposed parts. Oiling is typically applied for rust protection but is removable and not a forming lubricant.
• Weldability: Generally weldable with suitable procedures; however, spot welding becomes more difficult as carbon increases above ~0.15% and grades 490/550 are not recommended for welding due to reduction in strength by welding heat.
• Dimensional tolerances and coil size: Dimensional and shape tolerances referenced to ISO 16162; coil sizes and marking requirements are specified.

Applications and users

ISO 13887 is relevant to:

• Automotive and appliance manufacturers needing higher‑strength, formable cold‑reduced sheet for stamped parts
• Steel producers, mill quality control and metallurgists specifying production and heat analysis
• Fabricators, stampers and welders requiring documented mechanical and surface properties
• Procurement, inspection and standards compliance teams verifying material acceptance

Practical benefits include weight reduction through higher strength combined with improved formability and predictable mechanical and surface performance for forming applications.

Related standards

• ISO 6892‑1 - Tensile testing (room temperature)
• ISO 16162 - Dimensional and shape tolerances for cold‑rolled sheet
• ISO 3574, ISO 4997, ISO 14590 - Standards referenced for excluded steel categories

Keywords: ISO 13887, cold‑reduced steel sheet, higher yield strength, improved formability, steel grades, mechanical properties, chemical composition, tensile test, weldability, surface finish.