ISO 6316:2012

Overview

ISO 6316:2012 - Hot-rolled steel strip of structural quality specifies requirements for hot-rolled steel strip intended for structural applications where defined mechanical properties are required. The standard covers typical hot-rolled strip rolled on narrow strip mills and supplied in the delivered condition for bolted, riveted or welded structures. It excludes commercial/drawing quality (see ISO 6317), steels for boilers/pressure vessels, rerolling to cold-reduced products, and weathering steels.

Keywords: ISO 6316, hot-rolled steel strip, structural quality, steel strip standards, mechanical properties.

Key topics and technical requirements

• Material scope
  • Grades normally without microalloying: HR235, HR275, HR355.
  • Thickness range: 0.65 mm to 12 mm inclusive; widths up to 600 mm (exclusive).
• Chemical composition
  • Heat-analysis limits for C, Mn, Si, P, S are specified per grade (e.g., HR235 C ≤ 0.17 %; HR275 C ≤ 0.20 %; HR355 C ≤ 0.20 %).
  • Limits on additional elements (Cu, Ni, Cr, Mo, Nb, V, Ti) and rules for sums of certain elements.
• Mechanical properties
  • Minimum yield and tensile strength values given by grade (examples: HR235 Rmin ≈ 235 MPa / Rm min ≈ 330 MPa; HR355 Rmin ≈ 355 MPa / Rm min ≈ 450 MPa).
  • Elongation requirements and test-piece gauge length rules are defined.
• Manufacture and condition
  • Steelmaking processes are at manufacturer’s discretion unless otherwise agreed.
  • Surface condition, descaled vs. as-rolled, and optional oiling are addressed.
• Testing and inspection
  • Tensile testing per ISO 6892-1; Charpy V‑notch impact testing per ISO 148-1 when specified (typically for >6 mm).
  • Sampling, product/heat analysis, dimensional tolerances and acceptance criteria are defined.
• Practical provisions
  • Coil size, marking, purchaser information and workmanship requirements are included.

Applications

ISO 6316 is intended for structural hot-rolled strip used in:

• Fabricated steelwork (bolted, riveted or welded parts)
• Components produced from narrow-strip coil (brackets, channels, light structural members)
• General construction and manufacturing where consistent mechanical performance, weldability and dimensional tolerances are required

Keywords: structural steel strip, welded structures, narrow strip mill, coil supply.

Who should use this standard

• Steel producers and mills manufacturing hot-rolled strip
• Procurement and quality managers specifying structural strip for fabrication
• Design and fabrication engineers selecting materials for welded/bolted structures
• Inspection and testing laboratories performing compliance verification

Related standards

• ISO 6317 - Commercial and drawing quality hot-rolled strip
• ISO 6892-1 - Tensile testing of metallic materials
• ISO 148-1 - Charpy pendulum impact test

ISO 6316 helps ensure predictable chemical, mechanical and dimensional performance of hot-rolled structural strip-critical for safety, quality control and supplier-purchaser contracts in steel fabrication and construction.