EN ISO 11126-5:2018 PDF
Preparation of steel substrates before application of paints and related products - Specifications for non-metallic blast-cleaning abrasives - Part 5: Nickel slag (ISO 11126-5:2018)
Preparation of steel substrates before application of paints and related products - Specifications for non-metallic blast-cleaning abrasives - Part 5: Nickel slag (ISO 11126-5:2018)
- Статус документа:
- Действующий
- Формат:
- Электронный (PDF)
- Количество страниц:
- 12
- Дата публикации:
- 17 октября 2018 г.
- Издание:
- CEN EN 11126 edition 2 version 1
- ICS:
- 25.220.10
This document specifies requirements for nickel slag abrasives, as supplied for blast-cleaning processes. It specifies ranges of particle sizes and values for apparent density, Mohs hardness, moisture content, conductivity of aqueous extract and water-soluble chlorides. The requirements specified in this document apply to abrasives supplied in the "new" condition only. They do not apply to abrasives either during or after use. Test methods for non-metallic blast-cleaning abrasives are given in the various parts of ISO 11127. NOTE Although this document has been developed specifically to meet requirements for preparation of steelwork, the properties specified will generally be appropriate for use when preparing other material surfaces, or components, using blast-cleaning techniques. These techniques are described in ISO 8504‑2.
Abstract
Overview
EN ISO 11126-5:2018 - Preparation of steel substrates before application of paints and related products - Part 5: Nickel slag defines the specification for nickel slag non‑metallic blast‑cleaning abrasives supplied for shot or grit blasting. Published by CEN/ISO, this part of ISO 11126 sets material, size and contamination limits and cross‑references test methods in the ISO 11127 series. The standard applies to abrasives supplied in the new condition only and is intended primarily for steel preparation (but is generally suitable for other substrates prepared by blast‑cleaning).
Key topics and technical requirements
- Abrasive type and designation: Product designation follows the format "Abrasive ISO 11126 N/Nl1 (or N/NI2) /G or S " to identify nickel refinery slag (N/Nl1) or ferronickel slag (N/NI2), grit (G) or shot (S) and particle size (e.g., Abrasive ISO 11126 N/Nl1/G 0,2-1).
- Particle size distribution: Specific size ranges and tolerances are defined (see Table 1 in the standard); maximum particle size must not exceed 3.15 mm and particles
Технические детали
- Технический комитет
- CEN/TC 139 - Paints and varnishes
- SKU
- EN ISO 11126-5:2018
Похожие стандарты
Стандарты, упомянутые в описании