Overview
IEC 61300-2-4:2019 - "Fibre optic interconnecting devices and passive components - Basic test and measurement procedures - Part 2‑4: Tests - Fibre or cable retention" defines standardized procedures to verify that the retention or attachment of the fibre, cord or cable in a fibre‑optic device or enclosure will withstand the tensile load applied to the fibre, cord or cable during normal service. Edition 2.0 (2019) replaces the 1995 edition and adds normative references, clarifies test procedures and severities, and updates the document structure to current ISO/IEC Directives.
Key topics and technical requirements
- Purpose: ensure secure captivation/attachment of fibres, cords and cables to devices and enclosures under tensile loads.
- Failure modes addressed include: cable jacket damage, strength‑member damage, fibre breakage, clamp failure, cable pull‑out, loss of optical continuity or sealing, and changes in attenuation or return loss.
- Apparatus and setup requirements:
- Mandrel: diameter = greater of 60 mm or 25 × cable diameter (d); specified number of turns to prevent slippage. For optical components, distance A = 200 mm ± 50 mm; for closures, A ≥ 50 × d or 250 mm (min).
- Holding fixture: rigidly clamps DUT without distortion; allows optical monitoring if required.
- Force generator and force gauge: smoothly apply and register the specified tensile load and application rate. Alternative mass‑increment methods may be acceptable.
- Timer and optical/sealing measurement equipment as required by referenced IEC 61300 parts.
- Procedure overview: specimen preparation, pre‑conditioning, mounting and inspection, application of tensile load, conditioning/monitoring (optical/sealing), load removal, recovery and final examination.
- Severity: recommended severities are provided in tables for connectors, closures, wall outlets, hardened equipment, etc.; the 2019 edition clarifies these severities.
Practical applications
- Use IEC 61300-2-4 to verify the mechanical integrity of fibre assemblies, connectors, splice closures, optical wall outlets, and outdoor enclosures when subjected to tensile loads encountered in installation, handling or environmental stress.
- Typical outcomes: pass/fail retention verification, identification of weak cable clamps or seals, and validation of designs to prevent attenuation or sealing degradation under load.
Who should use this standard
- Fibre‑optic component manufacturers (connectors, adapters, closures)
- Test laboratories and quality assurance teams performing mechanical qualification and type‑approval tests
- System integrators, network installers and specifiers validating products for field deployment
- Designers of passive components and enclosures concerned with cable retention and strain relief
Related standards
Keywords: fibre or cable retention, tensile load applied to the fibre, cord or cable, mandrel, force gauge, fibre optic interconnecting devices.